I recently did this mod and it was pretty straight forward but I thought I would offer up the pics I took during the install.

Tools I used:
14mm Socket Ratchet Wrench
14mm Hand Wrench
WD40


First off you have to be able to get to the pitchmount. Remove your stock intake system or intercooler. Then just to loosten up the bolts I sprayed a little bit of wd40 on the bolts in the front and back.

There is basically 1 screw on each side of the pitchmount and the one on the back has a fixed nut.

Here is a pic of the passenger side of the back mounting point.

http://rs-scooby.com/albums/stipitchmount/DSCN1724.sized.jpg


Here is a pic of the drivers side fixed nut on the back mount

http://rs-scooby.com/albums/stipitchmount/DSCN1726.sized.jpg

and another one to show the location in the engine bay

http://rs-scooby.com/albums/stipitchmount/DSCN1729.sized.jpg



In the front is a removeable screw that has a bolt and washer on it.

Here is a pic of the front mounting point

http://rs-scooby.com/albums/stipitchmount/DSCN1725.sized.jpg



Finally here is a picture of it installed and also some comparison pictures between the stock mount and the sti one.



http://rs-scooby.com/albums/stipitchmount/DSCN1731.sized.jpg

http://rs-scooby.com/albums/stipitchmount/DSCN1719.sized.jpg

http://rs-scooby.com/albums/stipitchmount/DSCN1721.sized.jpg


Hope this helps!

Ryan

My install for the Pitch Link Here:

http://www.scoobymods.com/forums/showthread.php?t=168&highlight=Pitch+link