Tools needed:
<br>
<ul>
<li>12mm socket wrench
<li>Ramps help too
</ul>

<br><br>

This was very easy to install. My initial concern was if the bar would fit or not with the differential protector. As you can see it fits with very little room to spare. They supplied a backing plate that I suppose you were to use on the other side of the holes in the cross member. My 99' RS has nuts welded on the other side of the holes so I didn't need to use the plates. I purchased the bar from Teague's Auto.

<br><br>

<IMG src=/mods/impreza/images/cuscoarmbar1.jpg WIDTH="600" HEIGHT="171" ALIGN="BOTTOM" BORDER="0">
<IMG src=/mods/impreza/images/cuscoarmbar2.jpg WIDTH="500" HEIGHT="375" ALIGN="BOTTOM" BORDER="0">
<IMG src=/mods/impreza/images/cuscoarmbarmount3.jpg WIDTH="600" HEIGHT="408" ALIGN="BOTTOM" BORDER="0">
<IMG src=/mods/impreza/images/cuscoarmbarmount4.jpg WIDTH="600" HEIGHT="359" ALIGN="BOTTOM" BORDER="0">
<IMG src=/mods/impreza/images/cuscoarmbarmount5.jpg WIDTH="600" HEIGHT="479" ALIGN="BOTTOM" BORDER="0"><BR>
<BR>